This is a brief description of some of the most commonly used features of gdb.
-g flag. So, if your program is in a source
file called memsim.c and you want to put the executable
in the file memsim, then you would compile with the
following command:
gcc -g -o memsim memsim.c
gdb at the unix prompt. Gdb will
give you a prompt that looks like this: (gdb). From that
prompt you can run your program, look at variables, etc., using the
commands listed below (and others not listed). Or, you can start gdb
and give it the name of the program executable you want to debug by
saying
gdb executable
To exit the program
just type quit at the (gdb) prompt (actually
just typing q is good enough).
help will give you a list of topics. Then you can type
help topic to get information about that topic
(or it will give you more specific terms that you can ask for help
about). Or you can just type help command and
get information about any other command.
file executable specifies which program you
want to debug.
run will start the program running under gdb. (The
program that starts will be the one that you have previously selected
with the file command, or on the unix command line when
you started gdb. You can give command line arguments to your program
on the gdb command line the same way you would on the unix command
line, except that you are saying run instead of the
program name:
run 2048 24 4
You can even do input/output redirection: run >
outfile.txt.
break command.
break function sets the breakpoint at the
beginning of function. If your code is in
multiple files, you might need to specify
filename:function.
break linenumber or break
filename:linenumber sets the breakpoint to the given
line number in the source file. Execution will stop before that line
has been executed.
delete will delete all breakpoints that you have set.
delete number will delete breakpoint numbered
number. You can find out what number each
breakpoint is by doing info breakpoints. (The command
info can also be used to find out a lot of other stuff.
Do help info for more information.)
clear function will delete the breakpoint set at
that function. Similarly for linenumber,
filename:function, and
filename:linenumber.
continue will set the program running again, after you
have stopped it at a breakpoint.
step will go ahead and execute the current source line,
and then stop execution again before the next source line.
next will continue until the next source line in the
current function (actually, the current innermost stack frame, to be
precise). This is similar to step, except that if the
line about to be executed is a function call, then that function call
will be completely executed before execution stops again, whereas with
step execution will stop at the first line of the
function that is called.
until is like next, except that if you are
at the end of a loop, until will continue execution until
the loop is exited, whereas next will just take you
back up to the beginning of the loop. This is convenient if you want
to see what happens after the loop, but don't want to step through
every iteration.
list linenumber will print out some lines from the
source code around linenumber. If you give it the
argument function it will print out lines from the
beginning of that function. Just list without any
arguments will print out the lines just after the lines that you
printed out with the previous list command.
print expression will print out the value of the
expression, which could be just a variable name. To print out the
first 25 (for example) values in an array called
list, do
print list[0]@25